TANDEMKROSS Kraken Grip Frame for Ruger Mark IV and Mark IV 22/45 - TANDEMIZED

• Fully metallic lower replacing factory plastic
• Fully assembled and upgraded with all TANDEMKROSS parts and accessories
• Drop-in ready out of the box
• Compatible with virtually ALL factory or aftermarket Ruger Mark IV and Mark IV 22/45 uppers

The #TANDEMIZED Kraken is the single best way to get the most out of your Ruger Mark IV Standard or 22/45 pistol. What was once a stripped lower that required additional parts and assembly is now ready to host your pistols upper right out of the box! Increase the life and durability of your pistol while also increasing its reliability and performance!

TANDEMKROSSs Kraken boasts an enlarged trigger guard for large or gloved hands, a hooked trigger guard for more points of contact, and textured backstrap for improved grip and ergonomics. Additionally, the takedown button has been replaced by a single takedown screw that helps preserve the pistols simple takedown while reducing play between the lower and upper for a firm, secure hold. The cerakoted aluminum is also much less susceptible to damage from heat, chemicals, impact, or general wear and tear.

Since all Ruger Mark IV Standard and Mark IV 22/45 pistols share the same one-button takedown feature, the Kraken will support virtually any factory or aftermarket Ruger Mark IV or Mark IV 22/45 uppers. This means the Kraken allows you to easily turn any Ruger Mark IV into a Mark IV 22/45. All you need is to swap out the factory Mark IV magazine base pads with Mark IV 22/45 base pads. TANDEMKROSSs extended magazine bumpers perfectly fit the bill! Try either the Tomahawk or MarkPRO Magazine Bumpers that both come in packs of two.

This upgrade contains over 30 parts, components, and accessories, all from TANDEMKROSS and all fully installed, assembled, tested, and ready to go as soon as it arrives at your door. Whether for serious competition or recreational plinking, the #TANDEMIZED Kraken is perfect for anyone looking to improve their favorite rimfire pistol.

With the #TANDEMIZED Kraken youll receive:

• Blast Pack
• Bolt Keeper Extended Bolt Stop
• Bolt Stop Pin
• Bolt Stop and Stud
• Cornerstone Safety Thumb Ledge
• Engraved Titanium Grip Screws (4-Pack)
• hiveGrip
• Kraken Aluminum Lower
• Rebuild Kit*
• Safety
• Victory Trigger

Get the #TANDEMIZED Kraken for your Ruger Mark IV or Mark IV 22/45 today and make your good gun GREAT!

*Our rebuild kit comes installed in your #TANDEMIZED Kraken, and you will not receive the case that comes with a separate purchase of a rebuild kit.

Dont forget, all TANDEMKROSS products are made in the USA and come with a LIFETIME guarantee!